Service
Technical Manual
39
1220013692 - 11/2017
dormakaba digital cylinder
8.4
Disassembling the inner door knob
8.4.1
'Click' door knob
ü
Tool – Multitool ready
2
2
1
3
1.
Insert the multitool with the narrow pawl between the Knob and the fitting.
2.
Press the multitool against the fitting.
ð
The locking spring will release.
3.
Remove the Thumbturn knob.
8.4.2
'Small' inner knob
ü
Allen key, 2 mm hex available
2 mm
1.
Using the hexagonal key, loosen the screw from the inner door knob.
2.
Remove the door knob.
8.5
Configuration and traceback
Correctly set values for date and time ensure time management with the components is up-
to-date.
Components connected to the system software via the wireless function are updated via the
gateway (e.g. clock time, configurations). The traceback can be read using the system soft-
ware.
In standalone mode, configurations can be transmitted using the programmer or can be
changed with this (e.g. adjusting the clock time).
A programmer can read the traceback and transmit it to the system software for evaluation.
Further steps are described in the documents
Programmer 1460
and
Programmer 1364
.
8.6
Reset (INI reset)
INI reset of e-module
An INI reset can be used to restore the factory settings for the components.
NOTICE
Loss of data
With an INI reset, all previously saved settings and data on the E-module are deleted.
NOTICE
Before components are returned to Kaba for servicing, always carry out a
reset on the components.