© 2019 dormakaba Canada Inc
www.dormakaba.us • Phone: 1.800.265.6630 • Fax: 1.800.482.9795 • E-mail: sales_RCI@dormakaba.com
4
Frame
Self-Adhesive
Mounting Shim (8
incl.)
Mounting Tab
(2 incl.)
12-24 Machine
Screws (2 per tab)
Mounting Tab Kit Instructions
Mounting tab kit is for use with aluminum and steel frames that
do not have factory installed mounting tabs for electric strike
installation.
1. Prepare the frame as shown in the approximate
drawing. Fasten the mounting tab to the faceplate
of the strike, selecting the appropriate shims for the
installation.
2. Using the assembled strike and tabs as a template,
place against the frame and mark the mounting hole
locations. Remove and drill a 3/16” hole in frame for
each mounting tab and countersink the frame.
3. Remove the tabs from the faceplate and install in the
frame using the 12-24 x 3/8” machine screws supplied.
Tabs are zinc plated and drilled and tapped for this
purpose.
4. Make final electrical connections per wiring instructions
and mount strike to the tabs with the 12-24 x 3/8”
machine screws.
Trim Plate Instructions
1. Position the Trim Plate on the frame cut-out to verify fit
and coverage.
2. Adjust cut-out if required.
3. Bend the four tabs to hold the Trim Plate onto the
frame.
4. For a tighter fit, pre-bend the two long flange tabs
before sliding onto the frame where space allows.
5.
Secure the strike to the frame as per strike installation
instructions.
