Page 4
4. INSTALLATION
A typical roller door lock installation is described. The lock is being mounted on the floor while the strike will be
mounted on the door to the right of the lock.
4.1 Mark the lock position
Locate the lock in the desired position and
using a pen / pencil mark the three mounting
hole locations through the lock base.
4.2 Drill the lock mounting holes
Use a M8 masonry bit to drill the three mounting
holes in the concrete floor. Make the holes at
least 70mm deep.
4.3 Secure the lock in position
With the lock positioned over the holes in the
floor, install the three supplied Dyna bolts and
tighten them.
4.4 Mark the strikes position
Locate the strike in the correct position and
using a pen / pencil mark the three mounting
hole locations through the strike.
