Page 5
4.5 Drill the strikes mounting holes
Use a M8 drill bit to drill the three mounting
holes in the door.
4.6 Secure the strike in position
Position the strike over the three holes and
use M8 bolts / screws (not supplied) to
secure it to the door.
4.7 Wire the lock
Using a screwdriver and following the connection
guide on the printed circuit board, connect
the required wires to the lock.
Detailed wiring information can
be found in section 5 - Wiring
4.8 Cover the lock
Position the cover over the lock and push it
down and forward. Use the keyed cam lock
in the back of the cover to secure it in place.
