Outer cam
Groove at 12 o'clock
Inner cam
Left hand (LH)
1- Hold from rotating
2- Rotate to change
from LH to RH
Groove at 6 o'clock
Right hand (RH)
Click in place
"Wire Ring" opening far from slot
2 - Remove screw
1
WARNING
ALIGN STUD AND TAIL PIECE
GENTLY INTO DEAD BOLT
REMOVE TAPE
INSTALL TOP SCREWS
FIRST
CONNECT W1 TO W2
(COMMUNICATION
IF APPLICABLE)
CONNECT V1 TO
V2 (POWER)
ROTATE LEVER CW OR CCW, INSERT A 5/64 OR
2MM TOOL INTO ACCESS HOLE TO HOLD THE
HANDLE DOWN AND CLEAR PASSAGE FOR
SCREW
RUN CABLE THROUGH DOOR
AND UNDER DEADBOLT
RUN CABLES THROUGH INSIDE
TRIM BACKPLATE SLOT
3
3 - Carefully slide the cover off the lever
without scratching it.
ASSEMBLE TAIL PIECE
6.
ASSEMBLE OUTSIDE HOUSING
8.
ADJUST LOCK HANDING ON OUTSIDE HOUSING ASSEMBLY
5.
PK3710 - Rev 2
INSTALL INSIDE TRIM ASSEMBLY
9.
INSTALL 3 TOP SCREWS FIRST TO FRONT LOCK ASSEMBLY THEN
1.
INSTALL IN PLACE LEVER & ROSE ASSEMBLY.
INSTALL 2X BOTTOM SCREW TO LEVER & ROSE ASSEMBLY.
2.
OUTSIDE & INSIDE LOCK ASSEMBLY MUST BE ALIGN VERTICAL.
3.
BEFORE TIGHTENING THE SCREWS VERIFY FUNCTIONALITY BY
4.
EXTRACTING AND RETRACTING THE DEADBOLT. THE DEAD BOLT
SHOULD MOVE SMOOTHLY.
ALL SCREWS SHALL BE THIGHTEN PROPERLY.
5.
TIGHTEN ALL SCREWS.
6.
CONNECT WIRING V1 & V2 AND W1 & W2.
7.
INSTALLED 3X AA BATTERIES
8.
Hold inner cam in place, groove always points to 12 o'clock.
1.
Rotate outer cam counter clockwise until groove points to 6 o'clock
2.
REMOVE INSIDE COVER
7.
1 - Gently snap the door open.
WHILE INSERTING THE LEVER & ROSE
ASSEMBLY IN PLACE, MAKE SURE TO ALIGN
SPINDLE AND SCREW POST WITH THEIR
RESPECTIVE HOLE AND PUSH GENTLY IN.
