78
LEADING IN PRODUCTION EFFICIENCY
Operating Manual
© Dürr Systems AG
ED3K_Operating_Manual_Rev02LD_03Lug2020_EN. docx
Rev.02 – 03.07.2020
Figure 45 Parameters page 2
AUTOMATIC PURGE
Yes/No
If the system is equipped with EcoCleaner M device, with the option Yes the
pot life alarm activates an automatic purge cycle
MINIMUM FLOW A
[ml/min]
While spraying loading or purging, the flow of the medium is controlled. When
the measured flow in channel A is consistently less than the quantity here
specified, an alarm is raised with the delay specified in DELAY ALARM NO
FLOW / DELAY ALARM NO FLOW PURGE/LOAD. Default value 30 [ml/min]
MINIMUM FLOW B
[ml/min]
While spraying, loading or purging, the flow of the medium is controlled. When
the measured flow in channel B is consistently less than the quantity here
specified, an alarm is raised with the delay specified in DELAY ALARM NO
FLOW / DELAY ALARM NO FLOW PURGE/LOAD. Default value 20 [ml/min]
MINIMUM FLOW C
[ml/min]
While spraying, loading or purging, the flow of the medium is controlled. When
the measured flow in channel C is consistently less than the quantity here
specified, an alarm is raised with the delay specified in DELAY ALARM NO
FLOW / DELAY ALARM NO FLOW PURGE/LOAD. Default value 20 [ml/min]
DELAY SPRAY ON
[s]
After the loading cycle is finished the atomizing air is enabled with the delay
here specified. This parameter is useful when the system is not equipped with
EcoCleaner M.
If the system is equipped with EcoCleaner M, to be the atomizing air enabled
after the time above here specified, the gun must be out of the EcoCleaner M
and the cleaner box cover closed.
Default value 3 [s]
QUNTITY B - C FIRST
LOAD [ml]
Once the system has been purged, at the first following load, the YB (YC)
valve is kept opened, with the color valve closed, until the quantity here
specified has flowed, then the color and the YB (YC) valves are opened
according to the recipe mixing ratio. Default value 0 [ml]
LOAD / PURGE
REGULATOR
PRESSURE [bar]
Set of pressure during loading and purging cycle. Default value 6 [bar].
