109
LEADING IN PRODUCTION EFFICIENCY
Operating Manual
© Dürr Systems AG
ED3K_Operating_Manual_Rev02LD_03Lug2020_EN. docx
Rev.02 – 03.07.2020
Write in the recipe the output percentages of the regulator you want to measure the corresponding
flow,
set the output regulator in manual mode and press the key
.
An automatic procedure is carried out where, the sequence of the set points written in the recipe is
assigned to the output, and the corresponding values of the measured flow saved in the recipe
regulation table.
Figure 63 flow regulation – save flow set point in recipe data
The recipe set point can be change directly in this page, and then saved in the recipe data. The
key cancel restores the original flow set from the recipe.
8.11.3 Graphic representation
Figure 64 flow regulation – Graphic
