1
Product overview
1.1
Overview
Fig. 1: Product overview
1
Material connection for paint circulation
mode
2
Fix bracket with angular gauge
3
Material connection (M)
4
Control air connection (C)
5
End cap
6
Housing
7
Leakage groove
8
Reversible nozzle
9
Spray jet screen
10
Connecting piece
1.2
Short description
The spray gun is used for coating surfaces in
high pressure areas. Compressed air is used
to control the opening and closing of the
needle. The material to be atomized is fed
through high pressure lines. The operation
can be done with paint circulation or tap line.
Use a nozzle with a suitable diameter,
depending on the requirement. If there is a
blockage, you can rotate and flush the
nozzle through without disassembly.
Follow the special instructions
manual for spray jet screen and
the nozzle.
The following factors influence the spray jet
and therefore the result
Control air pressure
Opens the needle and controls the mate-
rial flow.
Material pressure
The higher the material pressure, the
higher the material flow and thus the finer
the atomization. The lower the material
pressure, the higher is the efficiency and
the smaller is the overspray generated.
Nozzle
The higher the bore diameter, the more
the material flowing out. The greater the
angle, the wider is the spray pattern.
Control air pressure and material pressure
are controlled externally via valves.
Product overview
01/2017
EcoGun AL AUTO - MSG00012EN
4/40
