7
6
5. Operation of the device
5.1 Device description
5.2 Installation of the device
NOTICE!
Please note our battery recommendation only: Use only the manufacturer's battery
NOTICE!
Please note our battery recommendation only: Use only the manufacturer's battery
type SAFT LS 14250 3.6 Volt or DYNAMIS Lithium Battery. LI-110 1/2 AA / S respectively. vom
Manufacturer release type Battery type. To commission, remove the logger from its packaging
and remove the display protective film. The logger is ready to be programmed and ready for
delivery. It can be used without software!
Before starting operation, the data logger will indicate for 2 seconds FS (Factory
setting) in motion or key press and then the current measurement values will be
displayed for 2 minutes, then the display will switch off. Moving or key presses the
measuring device again for 2 minutes in the described mode.
The display shows the current measurement values, extremes and average values per
measurement size. In the status bar, information is displayed for battery status, recording mode and
alarms. The green LED flashes during recording every 30 seconds. The red LED serves as an
indicator of border alarms. The logger also had an internal buzzer (beep tone) that supports the
operator's management and is used for alarms.
The product is suitable only for the above described range. Do not use the product
otherwise, as provided in this manual. No proper repair, alteration or modification of
the device is required.
FIG. A (
see page 2)
FIG. A (
see page 2)
1. USB protective cap
2. USB connection
3. LCD display see FIG. B
4. LED: red / green
5. Sensor compartment
(Position of Sensors)
6. Battery compartment
7. Fashion key
8. Start / Stop key
9. closable wall mount
10. External connectors (only TC)
11. External connector (only E)
FIG. B (
see page 2)
FIG. B (
see page 2)
1. Units in Measurement Value Line 1
2. Measurement value Line 1
3. Units in Measurement Value Line 2
4. Measured value line 2
5. Extreme sail
EXT = external sensor (only TC) AVG =
average value, MIN = minimum value,
MAX = maximum value
(no symbol) = current measurement value
6. Status bar (left to right): Battery
display, USB connection display,
Logger started, Logger configured,
iO, (without ► symbol) and
alarm not found iO (without ►
symbol)
5.2.1 Default setting on extradition
The default parameters are entered as default. With the LogConnect * software you can change the
parameters of your wishes accordingly. Memory Interval:
5 minutes LOG210 / LOG220, / LOG200 TC / LOG210 TC / LOG220 E 15
minutes LOG200 / LOG200 E
Measurement interval:
during the data recording, the measurement interval corresponds
to the storage interval (If the logger is not started, the logger
should be measured for 15 minutes at a 6 second rate, then for 24
hours at 15 minute rate, then measured at the hourly rate.
measured in 6-second clock.
Start possible by:
Taste
Stop possible by:
USB connection
Alarm:
out of
Alarm delay:
0 s
Display values in the display:
in the
Display Power Save Mode:
in the
Should the display (via Software Log Connect) be deactivated, only the battery symbol, the symbol logger
started (►) and / or logger configured (II) will be displayed in the status display.