11
10
5.5 PDF Statement (Fig. C)
Filename: eg
LOG220_16099908_2016-09-27T103123.PDF LOG220:
Dish
16099908:
Serial no.
2016-09-27:
Begin recording (date)
T103123:
Time: HHMMSS
Description:
can only be described with the LogConnect *
software.
Configuration:
preset parameters
Summary:
Overview of knife results
Graphics:
Visual representation of the measurement values
PURPLE:
Tells when whether Logger is moving
Signature:
In case of need to understand PDFs.
: Measurement OK
: Measurement is not in order
X
A
B
C
D
E
F
G
H
5.4 Stop recording / erase PDF (default setting)
Connect loggers with USB interface. Signalton
pours for approx. 1Sec.
LED blinks green until the PDF is displayed (can take up to 40
seconds).
The symbol ► in the status bar is not displayed anymore. The
logger has stopped! Signal tone is on and LED lights green.
Logger is displayed as a changeover data carrier LOG200 /
LOG210 / LOG220 / LOG200 TC / LOG210 TC / LOG200 E /
LOG220 E.
Open and secure PDF.
PDF will be overwritten at the next
launch!
NOTICE!
At the logger-start, the Extreme (Max- and Min-Value), as well as the average
NOTICE!
At the logger-start, the Extreme (Max- and Min-Value), as well as the average
value, were reset!
5.6 USB connection
To configure or evaluate the data loggers, the data logger must be connected to the USB
connection of your PCs. For configuration read the corresponding section in the manual
or in the help text of the LogConnect software.
* Download the free LogConnect Software: www.dostmann / electronic.de -> Downloads ->
Software / <Your Logger> / Software / LogConnect_XXX.zip (choose XXX latest version)
5.3.2 Memory used (%), date, time displayed
By briefly pressing the start key (after logger
start), it will be in row 1 MEM and in row 2 in
percent of the previously stored memory for
2 sec. display, then the image changes and
it is displayed for 2 sec. Date and time
displayed.
5.4.1 Stop recording via key or time point
is customizable via Software LogConnect.
In the corresponding setting, the Start key is also the Stop key.