Specification:
Use Type:
Single-use
Log Interval:
10mins (60days)
Data Storage Capacity:
10000 records
Start Delay:
30mins
Operating Temperature: -30°C...+60°C (22°F...140°F)
Storage:
Recommend 20% to 60% RH, 10°C to 50°C
Water Proof Level:
IP67
Dimension:
69mm x 33mm x 5mm
Standard Compliance:
CE, UKCA, EN12830, GSP
Communication Interface: USB2.0
Report Type:
Software:
No need install any software
1. Introduction
Dear Sir or Madam,
Thank you very much for purchasing one of our products. Before operating the data logger please read this manual carefully. You will
get useful information for understanding all functions.
2. Safety Instructions / Risk of injury / Kindly note
• Keep these devices and the batteries out of reach of children.
• Batteries contain harmful acids and may be hazardous if swallowed. If a battery is swallowed, this can lead to serious internal burns
and death within two hours. If you suspect a battery could have been swallowed or otherwise caught in the body, seek medical help
immediately.
• Batteries must not be thrown into a fire, short-circuited, taken apart or recharged. Risk of explosion!
• Don’t place the data logger directly into the corrosive liquid.
• Check if the contents of the package are undamaged and complete.
• For cleaning the instrument please do not use an abrasive cleaner only a dry or moist piece of soft cloth. Do not allow any liquid into
the interior of the device.
• Please store the measuring instrument in a dry and clean place.
• Avoid any force like shocks or pressure to the instrument.
• No responsibility is taken for irregular or incomplete measuring values and their results, the liability for subsequent damages is excluded!
•
Do not use the device in explosive areas. Danger of death!
•
Do not use the device in an environment hotter than 85°C! The battery may explode!
•
Do not expose the unsit to microwave radiantion. The battery may explode!
Product Profile:
PDF USB Temperature Data Logger is a cold chain data logger. It is mainly used for temperature recording during storage and transportation of
foodstuff, medicine, chemicals and other products. After record finishing, it can be inserted to computer’s USB port and get PDF report directly.
Operating Instruction:
1. Press and hold the button more than 3s. Then the “OK” light will brighten for 3s, which indicates a successful starting, then you can put the
data logger where you want to monitor and record.
2. When logging, the “OK” LED will flash in green every 10s, if there haven’ t any alarm events happened. Or the “ALARM” LED will flash in red
every 10s, if there have any alarm events happened.
* As standard, no alarm limits are stored in the TempLog TS. Special configurations of the logger on request.
3. When the memory is full or press and hold the button for more than 3s, the “ALARM” light will brighten for 3s, which indicates a successful
stopping.
4. Tear or cut off the plastic bag and insert the logger into an available USB port on a PC. “OK” light and “ALARM” light will flash in turn when a
PDF report is generating. When the PDF report has been generated, the “OK” light will bright until pulling out from the USB port.
(Note: If the logger is stopped during the status of start delay, there will be a PDF Report but no data.)
GB
