set password 111
set password
Description
Sets a user’s password for system interfaces (such as the CLI). A password can be entered as part of
the command, or the command prompts you to enter and re-enter the new password.
Min. role
manage
Syntax
set password
[password
password
]
[
user
]
Parameters
password
password
Optional. Sets a new password for the user. Input rules:
•
The value is case sensitive.
•
The value can have 8–32 characters.
•
The value can include printable UTF-8 characters except a space or: " ' , < > \
•
A value that includes only printable ASCII characters must include at least one uppercase
character, one lowercase character, and one non-alphabetic character.
If this parameter is omitted, the command prompts you to enter and re-enter a value, which is
displayed obscured for security reasons. For an SNMPv3 user whose
authentication-type
parameter is set to use authentication, this specifies the authentication password.
user
Optional. The user name for which to set the password. If this parameter is omitted, this command
affects the logged-in user’s password.
Example
Change the password for the default user,
manage
.
# set password manage
Enter new password: ********
Re-enter new password: ********
Change the password for user
JDoe
.
# set password JDoe password Abcd%1234
See also •
Summary of Contents for AssuredSAN 6004
Page 11: ...Document conventions and symbols 11 TIP Provides helpful hints and shortcuts...
Page 114: ...114 Alphabetical list of commands See also set cli parameters show protocols...
Page 139: ...show controller statistics 139 See also reset all statistics reset controller statistics...
Page 162: ...162 Alphabetical list of commands See also show power supplies...
