168 Alphabetical list of commands
show initiators
Description
Shows information about initiators. The command will show information about all initiators by
default, or you can use parameters to filter the output.
Initiator entries are automatically created for host initiators that have sent an
inquiry
command or
a
report luns
command to the system. This typically happens when the physical host containing
an initiator boots up or scans for devices. When the command is received, the system saves the host
port information. However, the information is retained after a restart only if you have set a name for
the initiator.
Syntax
show initiators
[
initiators
]
Parameters
initiators
Optional. A comma-separated list of the names of initiators for which to show information. If this
parameter is omitted, information is shown for all initiators.
Output
Nickname
The name of the initiator.
Discovered
•
Yes
: The initiator was discovered and its entry was automatically created.
•
No
: The initiator was manually created.
Mapped
Shows whether the initiator is explicitly mapped to any volumes:
•
Yes
: At least one volume is explicitly mapped to the initiator.
•
No
: No volumes are explicitly mapped to the initiator.
Host Type
The host-interface type.
ID
•
For a SAS initiator, its WWPN.
Example
Show information about all initiators.
# show initiators
Basetypes •
•
See also •
•
Summary of Contents for AssuredSAN 6004
Page 11: ...Document conventions and symbols 11 TIP Provides helpful hints and shortcuts...
Page 114: ...114 Alphabetical list of commands See also set cli parameters show protocols...
Page 139: ...show controller statistics 139 See also reset all statistics reset controller statistics...
Page 162: ...162 Alphabetical list of commands See also show power supplies...
