create user
41
roles
roles
Optional. Specifies the user’s roles as one or more of the following values:
•
monitor
: User can view but not change system settings. This is the default.
•
manage
: User can view and change system settings.
•
diagnostic
: User can view and change system settings.
Multiple values must be separated with a comma (with no spaces). If multiple values are specified,
the user’s access to commands will be determined by the highest role specified.
storage-size-base 2|10
Optional. Alias for
base
.
storage-size-precision
#
Optional. Alias for
precision
.
storage-size-units auto|MB|GB|TB
Optional. Alias for
units
.
temperature-scale celsius|c|fahrenheit|f
Optional. Sets the scale for display of temperature values:
•
fahrenheit
or
f
: Temperatures are shown in degrees Fahrenheit.
•
celsius
or
c
: Temperatures are shown in degrees Celsius. This is the default.
timeout
#
Optional. Sets the timeout value in seconds for the login session. Valid values are 120–43200
seconds (2–720 minutes). The default is 1800 seconds (30 minutes).
trap-host
IP-address
Optional. For an SNMPv3 user whose
interface
parameter is set to
snmptarget
, this specifies
the IP address of the host that will receive SNMP traps.
type novice|standard|advanced|diagnostic
Optional. Identifies the user’s experience level. This parameter is informational only and does not
affect access to commands. The default is
standard
.
units auto|MB|GB|TB
Optional. Sets the unit for display of storage-space sizes:
•
auto
: Sizes are shown in units determined by the system. This is the default.
•
MB
: Sizes are shown in megabytes.
•
GB
: Sizes are shown in gigabytes.
•
TB
: Sizes are shown in terabytes.
Based on the
precision
setting, if a size is too small to meaningfully display in the selected unit,
the system uses a smaller unit for that size. For example, if
units
is set to TB,
precision
is set to
1, and
base
is set to 10, the size 0.11709 TB is instead shown as 117.1 GB.
name
A name for the new user, which cannot already exist in the system. Input rules:
•
The value is case sensitive.
•
The value can have a maximum of 29 bytes, where ASCII characters are 1 byte, most Latin
(Western European) characters with diacritics are 2 bytes, and most Asian characters are 3
bytes.
•
The value can include printable UTF-8 characters except a spare or:
" , < \
•
A value that includes a space must be enclosed in double quotes.
Example
Create user
John
who will view system information using base 2 in the WBI.
# create user base 2 interfaces wbi roles monitor John
Enter new password: ********
Re-enter new password: ********
Summary of Contents for AssuredSAN 6004
Page 11: ...Document conventions and symbols 11 TIP Provides helpful hints and shortcuts...
Page 114: ...114 Alphabetical list of commands See also set cli parameters show protocols...
Page 139: ...show controller statistics 139 See also reset all statistics reset controller statistics...
Page 162: ...162 Alphabetical list of commands See also show power supplies...
