4 threads are visible
outside the nut.
Page 10
Step 9: Assemble the sensor handlebar
Attach the sensor handlebar(No.6) to the main pipe(No.2).
Screw two M8*16mm Allen bolts(No.74), two M8 split
washers(No.86) and two M8 curved washer(No.65) with
M6 Allen wrench(No.95).
2
6
74
86
65
Step 10: Assemble the monitor
Unscrew two M5*12mm bolts(No.80) from the back of
the monitor(No.5) with the socket wrench(No.94).
Connect the cable of monitor(No.5) to the main pipe.
Attach the monitor to the head of the main pipe. Screw two
M5 bolts back.
Finally, insert the plug of the sensor to the monitor and
install two AAA batteries.
5
2
75
80
49
Attention:
After Assemble, please tighten all bolts of the above steps.
Especially, when tightening the bolts between the main pipe and frame, please
ensure that
3 to 4
threads are visible outside the nut to avoid any wobbling.
+
+