Page 6
Assembly
Method
3
73
65
65
82
82
1
65
82
4
1
23
65 82
73
Step 1: Assemble the foot pipes
To assemble both foot pipes, please prepare front foot pipe
(No.3), rear foot pipe(No.4), four M8 curved washers
(No.65), four M8*65mm carriage bolts(No.73), four M8
acorn nuts(No.82), and socket wrench(No.94).
Attention:
There are two kinds of foot pipes. The front foot
pipe has two wheels, another one doesn’t have wheels.
Please assemble the front foot pipe with wheels in front of
the main frame.
Insert two M8*65mm carriage bolts from the bottom of
each foot pipe, and then screw two M8 acorn nuts and two
M8 curved washers by using the wrench.
The wheels face outward.
Step 2: Connect the wires in the main pipe
A
B
C
21
20
20
A
A
2
21
20
7
1
49
adjust to the top gear
For the assembly video, please visit Doufit Youtube:
www.youtube.com/channel/UCorBKk34KZgI96OyGSkjFdA
Attention
：
Don’t tighten all bolts until you finish all assembly steps.
Firstly, adjust the resistance to the 8th gear.
The resistance cable will become more longer.
Secondly, connect the motion sensor cables(No.7)(No.49)
carefully.
Thirdly, insert the bottom of above resistance cable(No.20)
into the wire clip of metal bracket(No.21).
Fourthly, firmly pull the resistance cable upward and slide
it into the top of the metal bracket.
Finally, before insert the main piep, reduce the resistance
gear
,
to prevent the resisance cable unhooks.
