8
3.
After servicing, reassemble and install in reverse.
Make sure tank O-Ring and sealing areas are free
of any dirt or grit and the o-ring is evenly seated
before replacing cover.
WINTERIZING FILTER
In areas subject to freezing damage, it is mandatory that
the filter, pump and any related components be re-
moved from the pool and stored indoors. (Refer to
individual components owners guide such as pump,
skimmer, chlorinator, etc., for specific winterizing
instructions.)
1.
Siphon water level down below skimmer opening by
using your vacuum hose and allow water to flow to
an area that can accept a couple of thousand
gallons or more.
2.
Drain tank completely.
3.
Disconnect all line connections.
4.
Remove V-Clamp from filter and remove cover and
gasket.
5.
Remove cartridges, flush out tank, clean cartridges
thoroughly and allow to dry completely.
6.
Reinstall cartridges only after they have dried
completely. Replace cover and drain cap.
7.
Store all components in a warm dry area indoors.
DAMAGE CAUSED BY FREEZING TEMPERATURES
IS NOT COVERED BY PRODUCT WARRANTY.
LUBE VALVE SHAFT
To lubricate the O-Ring on the valve shaft, depress
valve handle fully and apply lubricant on the shaft
between handle and valve cover. Then, rotate handle to
distribute lubricant. Resume normal filter operation by
rotating handle to the Filter position and start pump.
REPAIRS
Servicing should be performed by a qualified dealer. If
disassembly is attempted, mark each of the parts
assembled position as it relates to its mating parts. This
assures proper alignment when reassembled. Malfunc-
tion will occur if not properly assembled. See your
dealer for original replacement parts.
CAUTION
BEFORE removing filter or pump from pool for servic-
ing, prevent the backflow of water from your skimmer
and return fitting inlet from flowing out of disconnected
hoses.
1.
Remove skimmer cover and basket and plug inside
bottom hole with rag.
2.
Referring to the instructions for your return fitting,
install the Shutoff disc. Option; stuff a rag into the
return fitting opening.
3.
Disconnect hoses on filter or pump as necessary
when removing for service or repairs.
DRAIN TANK
See Caution Above
1.
Remove tank drain cap to drain.
2.
Remove V-Clamp, cover and large O-Ring from
tank.
