15
5
. For units configured with external thermistor only
- To install the thermistor, locate
a position near the middle of the battery between four cells. This location should
not have a metal plate running between the cells. Use the Phillips screwdriver to
make a small passage for the battery thermistor. Holding the battery thermistor
at the top, slide it down and into the passage made by the screwdriver.
CAUTION! A (1) Amp, 250V inline fuse must be
added at the termination point of the DataTrac
positive power connection, so that in the event
that the DataTrac power lead is damaged, it
does not create a possible current path.
ATTENTION! Un fusible en série de 250 V, 1 A
doit être ajouté au point de terminaison de la
connexion électrique positive de l’DataTrac,
afin qu’un passage de courant ne soit pas
créé dans le cas où le câble d’alimentation est
endommagé.
