Lit. No. 72936, Rev. 01
13
October 15, 2019
SET UP SPINNER DRIVE ASSEMBLY IN
OPERATING POSITION
To move the spinner drive assembly from storage/
shipping position to operating position:
1. Remove the fasteners securing the spinner drive
assembly to the chute supports. Discard the
fasteners and blocking (not shown).
NOTE: After removing the fasteners, the spinner
drive assembly will no longer be attached to the
spreader. Use caution to avoid causing personal
injury and/or damaging the spinner drive assembly.
2. Carefully set the spinner drive assembly on the
ground. Orient it in operating position as shown
below.
3. Install the lock pins found in the parts box to
attach the spinner drive assembly to the chute
supports.
Install the top lock pin
fi
rst
, using the
lower holes in the chute supports. Secure each
locking pin with a cotter pin.
4. Connect the spinner motor harness to the female
connector extending from the rear of the hopper.
TOP SCREENS & SPINNER DRIVE ASSEMBLY
Lock Pins
Spinner Drive
Assembly
Rotated Down
Chute Supports
Cotter
Pins
Female
Connector
3/8" x 3-1/2"
Cap Screw
3/8" Locknut
Spreader
Cross
Beam
Top Screen
Bracket
INSTALL BRACKETS AND
TOP SCREENS
1. If the top screens were previously removed for
lifting, put them back into place on the hopper
cross beams.
2. Install a top screen bracket at each end of
the spreader cross beams using the supplied
3/8" x 3-1/2" cap screws and 3/8" locknuts to
secure the top screens to the cross beams.
