GTB Series
14
Dimensions and technical information are subject to change without notice
Servo Positioner Rotary Table | Unit Description
e) If work is necessary on live parts, have a second person standing by who can turn off the master switch
or emergency stop switch in the event of an emergency. Cordon off the working area with a red/white
safety chain and a warning sign. Use only insulated tools and equipment!
f) When working on high-voltage assemblies, switch off the power supply, connect the supply cable to earth
and short-circuit the components, e.g. capacitors, with a ground rod.
Hydraulic/Pneumatics
a) Work on this equipment may only be carried out by persons with specialist know-how and experience!
b) Inspect all lines, hoses and screw fittings at regular intervals for leaks and obvious signs of damage!
Repair damage immediately! Escaping oil can lead to injuries and fires.
c) Depressurise system sections and pressure lines to be opened in accordance with the descriptions of the
assemblies before starting the repair work!
d) Lay and install hydraulic and compressed air lines correctly! Do not confuse connections. Fittings, lengths
and qualities of the hoses must comply with the requirements.
Noise
a) Soundproofing installations on the unit must be functional during operation.
b) Wear the prescribed personal protective equipment (ear protectors)!
Greases and other chemical substances
a) Process media must be used and disposed of in accordance with the instruction of the manufacturers of
these substances.
b) Pay attention with hot process media (risk of burns and scalding)!
Gas, dust, steam, fumes
a) Carry out welding, flame cutting and grinding work on the unit only when this is permitted. There is a
risk of fire and explosion!
b) Before starting welding, flame cutting and grinding work, clean the unit and its environment of dust and
inflammable substances and ensure adequate ventilation (explosion hazard)!
c) Inspect fume extraction and ventilation systems at regular intervals and check for proper function!
d) When working in confined spaces, observe any applicable national regulations! (e.g. have a second
person standing by for a fast rescue)
4.8 Safety and Monitoring Installations
• No safety or monitoring equipment is included with this unit
• All safety and monitoring installations, as well as their legal compliance with relevant ordinances, fall
under the responsibility of the end-user/owner
4.9 Warning Devices
• No warning devices are included with this unit
• All warning devices, as well as their legal compliance with relevant ordinances, fall under the
responsibility of the end-user/owner
