GTB Series
25
Dimensions and technical information are subject to change without notice
Servo Positioner Rotary Table | Installation
3. Installation
TD‐G17‐0003‐00
14
2．Insert the motor shaft into the coupling hole.
（The motor shaft must be removing fat and oil beforehand, and wiping off a dirt.）
3．Tighten the coupling fastening screw of the
coupling.
Insert the wrench from the access hole of the
motor mounting flange and tighten the
fastening screw of the coupling. (See Table4)
Caution!
•
The number of coupling fastening screws varies
depending on the model.
•
When there are two coupling fastening screws,
the access hole is also on the reverse side.
Tighten the two screws little by little
alternately and finally tighten with the specified
torque.
3. Installation
TD‐G17‐0003‐00
14
2．Insert the motor shaft into the coupling hole.
（The motor shaft must be removing fat and oil beforehand, and wiping off a dirt.）
3．Tighten the coupling fastening screw of the
coupling.
Insert the wrench from the access hole of the
motor mounting flange and tighten the
fastening screw of the coupling. (See Table4)
Caution!
•
The number of coupling fastening screws varies
depending on the model.
•
When there are two coupling fastening screws,
the access hole is also on the reverse side.
Tighten the two screws little by little
alternately and finally tighten with the specified
torque.
3. Tighten the coupling fastening screw
of the coupling. Insert the wrench from
the access hole of the motor mounting
flange and tighten the fastening screw
of the coupling. (See Table 4).
Caution !
• The number of coupling fastening screws
varies depending on the model.
• When there are two coupling fastening
screws, the access hole is also on the
reverse side. Tighten the two screws little
by little alternately and finally tighten
with the specified torque.
2. Insert the motor shaft into the coupling hole.
The motor shaft must be removing fat and oil beforehand, and wiping off a dirt.
