C A U T I O N
Installation of 3rd-party materials may result in
diminished case performance.
▲
ELECTRICAL
Electrical hookups are made through the power supply box
that can be accessed by removing the front (or rear) toekick
panel.
Note: The location of the power supply box corre-
sponds with the location of the heat controls.
For case-to-case wiring, run conduit between the power supply
boxes or run wiring through the raceway. When connecting to
the power supply on the case, fi eld wiring should exit box from
the side furthest away from case wiring to allow more room in-
side for wiring connections. Always check the data tag located
on left end
exterior panel or top interior
of the case. The case
must be grounded.
For more detailed electrical wiring informa-
tion (see Appendix A1).
C A U T I O N
Be certain that all electrical connections are
compliant with local codes.
▲
2.
Once the case is properly placed on the shim packs, check
the horizontal level of the case by placing a bubble level
on the front sill. Add/remove shim packs as needed.
3.
Install the bumper, if applicable, into pre-attached bumper
track and snap into place.
4.
After suffi cient time has passed to allow for bumper
shrinkage, cut away the excess bumper for fi nal fi t and fi n-
ish. Be certain to use an appropriate cutting tool (tubing-
or PVC-cutter) to ensure a smooth cut.
5.
Install case shelves and reconnect lights with the white
power cord(s) and the heat with the black power cord(s).
Color matching white/black receptacles can be found at
opposite ends of the inside back of the case. Be aware
that differing shelf confi gurations will affect energy con-
sumption and case performance.
6.
Install toekick back onto the base of case.
CASE INSTALLATION
13
