T
RITON
S
YSTEMS
E
LECTRONIC
L
OCK
I
NSTALLATION
M
ODEL
9100 C
ASH
D
ISPENSER
2
Mechanical Lock Removal Procedure
Before the electronic lock assembly can be installed the
existing mechanical combination lock must be removed.
Follow these steps to remove the existing mechanical
lock:
1.
Disconnect power to the unit and open the security
container door by lifting up on the door handle and
swinging the door outward.
Note that the door handle and cabinet lock bar is
held in the raised position by a latching catch
mechanism on the rear of the door, as shown here:
Allow the lock bar to stay in this position. You will be
directed to manually release the latch catch to test
the operation of the electronic lock in a later step.
2.
Remove the two screws that attach the deadbolt
cover to the deadbolt and remove the cover.
3.
Remove the brass shaft key located in the center of
the spindle by pulling directly out on it with a pair of
pliers (see Figure 1). Unscrew the outer combination
dial from the black spindle wheel and remove both
the dial and the wheel from the lock assembly.
4.
Remove the four screws that attach the deadbolt
assembly to the inside of the door and remove the
deadbolt assembly.
5.
Remove the two screws that attach the dial plate to
the cabinet door and remove the dial plate.
Figure 1. Latch catch closed, holding
lock bar in raised (unlocked) position.
Figure 2 Mechanical combination lock (cover
removed).
