3
If the equipment is causing harm to the network, the telephone company may request
that you disconnect the equipment until the problem is resolved. Repairs should be
made only by qualified factory representatives.
Party Lines: The RL5000 series ATM must not be used on party lines.
Alarm Equipment: The RL5000 series ATM should have its own dedicated phone
line. Do not install the RL5000 on the same line as alarm equipment.
Electrical Safety Advisory: Telephone companies report that electrical surges,
typically lightening transients, are very destructive to customer equipment connected
to AC power sources. This has been identified as a major nationwide problem. A
commercially available, power surge suppressor, is recommended for use with the
RL5000 to minimize damage in the event of an electrical surge.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The equip-
ment must also be installed using an acceptable method of connection. The cus-
tomer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
CANADIAN IC COMPLIANCE
NOTICE:
The Industry Canada label identifies certified equipment. This certification means
that the equipment meets telecommunications network protective, operational and
safety requirements as prescribed in the appropriate terminal equipment technical
requirements document(s). The department does not guarantee the equipment will
operate to the user’s satisfaction.
Repairs to certified equipment should be coordinated by a representative desig-
nated by the supplier. Any repairs or alterations made by the user to this equipment
or equipment malfunctions may give the telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections
of the power utility, telephone lines and internal metallic water pipe system, if present,
are connected together. This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority or electrician as appropriate.
NOTICE:
The Ringer Equivalence Number (REN) assigned to each terminal device provides
an indication of the maximum number of terminals allowed to be connected to a
telephone interface. The termination on an interface may consist of any combina-
tion of devices subject only to the requirement that the sum of the RENs of all the
devices does not exceed 5
.
RL5000 S
ERIES
I
NSTALLATION
G
UIDE
Summary of Contents for Triton RL5000 Series
