10
D. GEAR SECTION DISASSEMBLY
1. Drain the oil by removing the plug (85)
located on the bottom of the adapter cover
(58).
2. To disassemble the gear section, remove
the Intelliguard™ spacer (39) from the outer
cover (55) by removing three capscrews
(44). Inspect the gear teeth on the
Intelliguard™ (39) for wear. The
Intelliguard™ system is not serviceable in
the field. Return to an authorized dealer for
service.
3. Remove the outer cover (55) by removing
the ten capscrews (112).
4. Inspect the o-rings (57 & 114) for wear and
replace if necessary
5. Remove the input gear set (42) along with
the inner and outer thrust washers (43)
Inspect and replace if necessary.
6. Remove the sun gear (45) and secondary
gear set (41). Inspect and replace if
necessary.
7. Remove the primary housing (58) by
removing eight capscrews (32). Inspect the
o-ring (59) and replace if necessary.
8. Remove the spacer (28) and sun gear (46).
Inspect for wear and replace if necessary.
9. Remove the snap ring (47) from the output
shaft (38).
10. Remove the output gear set (40) and thrust
washer (37). Inspect and replace if
necessary.
Summary of Contents for TWG Tulsa RUFNEK 80
Page 9: ...9 CLUTCH INSPECTION ...
Page 26: ...26 VISCOSITY CHART ...