Dovre 280, Instructions For Use Installation And Servicing

21

Servicing Instructions - Replacing Parts

3. Window Frame Assembly

3.1  Remove the glass frame by undoing the fixing screws and 

lifting clear, see Diagram 3. Take care to support the glass 

window panel when removing the screws. 

3

3.2  Place carefully to one side.

3.3  Lift out the log guard and carefully remove the ceramic fuel 

bed components.

3.4  Refit in reverse order.

3.5  Ensure that the rope seal on the back of the glass frame is 

intact and replace the screws working from the top down. 

Tighten the screws evenly DO NOT OVER  TIGHTEN, see 

Diagram 3.

NEVER OPERATE THE APPLIANCE WHEN THE GLASS 

FRAME IS REMOVED OR BROKEN.

3.6  Replace ALL of the securing screws ensuring that a screw is 

present in all fixing slots.

UNDER NO CIRCUMSTANCES SHOULD THE 

APPLIANCE BE USED IF ANY OF THE GLASS 

FRAME RETAINING SCREWS ARE LOOSE OR 

MISSING.

1. General

1.1  All main components can be replaced without removing the 

appliance from its installation. 

1.2  Ensure the appliance and surrounds are cool before servicing.

IT IS ESSENTIAL THAT THE GAS SUPPLY TO THE 

APPLIANCE IS TURNED OFF AT THE ISOLATION 

DEVICE BEFORE PROCEEDING FURTHER.

2. Removing the Door

IMPORTANT: THE OUTER PANELLING OF THE 

APPLIANCE IS MADE FROM CAST IRON. USE 

CAUTION WHEN INSTALLING, REMOVING AND 

STORING AS THE COMPONENTS ARE HEAVY AND 

SHOULD BE HANDLED CAREFULLY. 

2.1  For rear flue exit lift the top of the appliance off and put to 

one side.

2.2  For top flue exit lift and support the top to give clearance, 

see Diagram 1.

1

Lift the front upwards until it is clear of the slots and pull 

away from the appliance, see Diagram 2.

2