DV425TR DIRECT VENT ROOM HEATER
02/01 Page 11 250-5533
7. Re-install inner flue collar on rear of stove with
damper rod pointing up. See Fig. 5 A dab of
high temperature silicone on the gasket will help
gasket adhere to the unit.
8. Re-install inner flue cover on top of stove, double
check that damper rod is in the up position. See
Fig. 6
9. Install outer cover plate, (with damper adjustment
plate attached), to top of stove. See Fig. 7
10. On top of stove: Reinstall damper adjustment
plate: a) set spacer in place, b) align adjustment
plate, c) set screw into spacer and tighten. See
Fig. 7
11. Re-install outer flue collar on rear of stove. See
Fig. 8
12. Install rear vent cover plate, supplied with kit, on
back shield.
13. Install top cast insert. NOTE: A grill cover plate
is shipped with the stove. This plate may be
placed beneath the top grill. See page 17 for
installation instructions. The use of the plate
increases blower efficiency and also hides the
interior of unit from view.
STEP B: Replace Burner Orifice: See next page.
FIG. 5
FIG. 6
Outer Cover
Plate
Damper
Adj. Plate
FIG. 7
FIG. 8
REAR VENT CONVERSION INSTRUCTIONS, cont.
