8
power up
1
4
2
3
Control
Board
Remove motor cover, and control board cover.
Remove existing black wires from
22VAC INPUT terminals. Pull them
through, out of the way.
Connect the brown-blue wires from
the battery into the 22VAC INPUT
terminals.
Control Board
22VAC
INPUT
5
Cover solar panel, connect black-red power
cables to Solar Panel and Batteries. Motor’s
control board plus solar controller are now
active. Controller may need to be turned on.
Cable tie the power cables against post.
Thread battery cable and aerial coaxial cable through the hole.
Strip the ends of cables.
Seal hole with silicone sealer. This will avoid problems caused when insects
nest in the motor.
TIP
Motor bottom view
Punch a hole in the grommet on motor base.
Grommet
