9
PUT IN SOLAR MODE
1.
Scroll to
P061
& Press OK
2.
Change parameter to
d001
.
3.
Scroll back to (
- - - -
)
4.
Test Remote Control operates gate. If it works just fine, replace the
Control Board Cover and Motor Cover cos you’re done!
NOTE:
when is solar mode, the LCD will turn off and blink once every 10 seconds
CONNECT THE AERIAL
1.
Thread aerial cable via the hole under the motor.
2.
Strip the outer cable approx. 50mm.
Separate the inner & outer wires.
Twist the outer wire.
3.
Strip end off the clear inner
insulation. Trim wires so both
are same length.
4.
Attach wires to the Control
Board (shown).
Something not working the way it should?
Call our Tech Team
SOS
1800 241 733
Aerial
Terminals
Control Board
CONNECT THE REMOTE
1.
Scroll to
P005
& press
OK
2.
When
LEAr
shows press the
remote button.
r000
shows a remote is connected.
Repeat step
2
for extra remotes as needed.
r001
shows when a second remote is connected.
r010
shows when the tenth remote is connected etc. etc.
3.
Wait 10sec. for the (
- - - -
) symbol to confirm memory
process is complete.