1.
Adjust the Post Brackets to fit the
Gate Post width and tighten.
2.
Mount Post Bracket with bottom edge on the mark. (#4 previous page)
3.
Remove a Top Cover off a motor to find which one houses the
electronic Control Board.
4.
Bolt both Motors to Post Brackets
5.
Bolt the Arms to Motors. Pin the thin arm Arm onto the thick arm.
The thin arm fits left or right hand gates.
6.
Pin the Universal Gate Bracket to the Thin Arm and mount
it to the gate stay. The bracket clamp rotates to fit any angle.
BRACKETS
GATE THIS
SIDE
>>>>
3