1.
Dig a channel between motors for conduit.
2.
Run the Figure-8 and 4-core cable through conduit.
3.
Bury the conduit and connect the cables as shown below.
Use 0.75mm figure-8, 2-core cable and 4-core (three used, one spare)
0.5mm cable in conduit (not supplied).
24V cable is safe to be buried at any depth.
NOTE
CONNECT MOTOR TWO
7
Motor One
4.
Place the fuse (inside Battery Box door) into the fuse holder on the red
power cable. The batteries are fully charged so it may spark. That’s OK,
24V is completely safe.
5.
With the carton still covering the solar panel, connect the black and red
power cables to the Solar Panel and Battery. The digital screen on
the motor’s control board and solar controller screen will light up.
6.
Cable tie the power cables to the post.
MOTOR ONE
MOTOR TWO
4-core
figure-8
