Figure 1
Figure 2
INSTALLATION INFORMATION
DC
P
OWER
C
ONNECTIONS
A wide voltage range is accepted (6V to 25V DC). All power jacks are compatible with 2.1mm x
5.5mm DC power plugs. The center pin is (+) positive polarity.
A summary of the four DC power jacks is as follows:
6-25V DC IN (Front Panel):
DC Power input, see Figure
1. Can be a battery or voltage regulated AC-DC adapter.
Typically a high capacity 2S or 3S LiPO battery is used.
DC-OUT (Rear Panel):
The voltage applied to the front panel’s DC-IN is conveniently
available on three rear panel accessible power jacks (see Figure 2). These are intended
for powering your three FPV receivers. Do not connect any other accessories such as
monitors or goggles to them.
For safety the DC-OUT jacks are fuse protected. The maximum combined current must
be less than 1.25A which is sufficient to power three common Video Receivers (vRx’s). If
the fuse is tripped then it can be automatically reset as follows (1) disconnect power, (2)
correct the over-current fault, and (3) re-apply power.
I
MPORTANT
: Never connect external power to the rear panel mounted DC-OUT jacks!
ALWAYS use the DC-IN (on the front panel) to power the Diversity Demon.
H
ELPFUL
T
IP
: Using the rear panel DC-OUT jacks is optional. Installations
with unusual vRx power requirements can simply ignore the DC-OUT
jacks and instead connect the vRx’s to an alternate external power source.
Diversity Demon ©2016-2017 DIGITAL PRODUCTS COMPANY
P
AGE
2
July-31-2017
