SYSTEM PROGRAMMING INSTRUCTIONS
Diversity Demon must be configured to your requirements. The system programming feature
allows you to set the following parameters:
#
Video Type (NTSC/PAL).
#
Switching Alert Chirp (On/Off).
#
Missing Receiver Red LED Alert (On/Off).
#
Low Battery Alert Beep (On/Off).
#
Low Battery Alert Voltage (6.0V - 24.9V).
#
Switching Sensitivity.
#
Video Level Balance Adjustment.
Programming Diversity Demon involves pressing the front pushbutton switch while observing
the LED indicators. The Green RX1
LED’s blink pattern indicates the programming step; There
are eight steps and each has a unique RX1 LED pattern. The programmed settings are saved
at each programming step and they are retained even if power is disconnected.
At each step you have a brief time to enter a new setting; Pushbutton presses are used to
program your preferred parameters. For example, during the “Video Type” programming step
you would press the switch twice to select the PAL video mode. After each entry you will wait
about three seconds for the Red S
TATUS
LED to wink and programming will proceed to the next
step. Programming can be terminated early by disconnecting power and any remaining steps
will remain as-is.
Note: If your entry is illegal then the three RX LED’s will rapidly flash Green for a couple
seconds as a warning that you have requested an undefined setting value. You w ill then be able
to re-enter your corrected entry.
If a pushbutton response is not entered within seven seconds then Diversity Demon’s Green
RX2 LED will report the existing setting by blinking out its code value. The stored setting will
NOT change and programming will continue to the next step immediately after the code value is
displayed.
Diversity Demon ©2016-2017 DIGITAL PRODUCTS COMPANY
P
AGE
7
July-31-2017
