The LED patterns are arranged as simple patterns of short and long blinks. The following table
outlines the blink codes (
S
= short blink,
L
= long blink).
STEP
VID2 LED
DESCRIPTION
1
S
Video Type, 1=NTSC / 2=PAL
2
S
-
S
Switching Alert Chirp, 1=ON / 2=OFF
3
S
-
S
-
S
Missing RX Red LED Alert, 1=ON / 2=OFF
4
S
-
S
-
S
-
S
Low Battery Alert Beep, 1=ON / 2=OFF
5
S
-
L
Main Low Battery Alert Voltage, 6 - 24 VDC
6
S
-
S
-
L
Fractional Low Battery Alert Voltage,
0.0 - 0.9 VDC
7
S
-
S
-
S
-
L
Switching Sensitivity, 1=LOWEST, 5=HIGHEST
8
S
-
S
-
L
-
L
Video Level Balance Adjustment,
1=ON / 2=SKIP
S
TART OF
P
ROGRAMMING
Programming begins by holding down the pushbutton switch while you apply power. Continue to
press the switch until the Red S
TATUS
LED is on. The audio buzzer will also begin to sound off.
When you are ready start programming, release the switch. RX1's green LED blink pattern will
indicate the step number.
Step 1:
S
Video Type.
Range: 1= NTSC, 2= PAL
This entry must be set to match the composite video type used by your camera and
display monitor. For example, press once for NTSC video.
Step 2:
S
S
Switching Alert Chirp
Range: 1= On, 2= Off.
This entry is used to control the audio alert that is heard whenever the video
sources are automatically switched. For example, press twice to disable the chirp
noise.
Diversity Demon ©2016-2017 DIGITAL PRODUCTS COMPANY
P
AGE
8
July-31-2017
