23
EN
Faceblank distinguishing colour:
Material
Half mask body
Colour of the half mask harness
POLIMASK …(Rubber)
BLACK
ORANGE
POLIMASK … SIL (Silicon)
YELLOW
BLACK
7
Operating principles
POLIMASK series halfmasks enclose the mouth, nose and chin. The face seal
passes over the bridge of the nose, round the cheeks and chin. The inhaled hair
flows through the inhalation valve in the connector and to the inside of the half
mask. The exhaled air is expelled outside through the exhalation valve.
8
Masks components
POLIMASK half masks are made up of the main components shown in the pictu-
res at the end of this manual. the halfmasks weight approx:
Model
Weight gr
POLIMASK 100/2
145
POLIMASK 230
165
POLIMASK 330
200
POLIMASK 2000 α
200
POLIMASK 2000 β
200
POLIMASK 2000 γ
200
9
Instruction for use
9.1
Filter assembling
Having chosen the appropriate filter, see related instructions for use. While
screwing and unscrewing filters, always hold from the connector side.
Note: It is advisable that filters left in the open air on the respirator for some
days, even without being used, be replaced prior to next use.
9.2 Donning
The filter which has been chosen for use with POLIMASK must be appropriate
for the intended use, compatible with the mask model chosen and in perfect
conditions. The connection of the filter with the mask and the donning must be
carried out outside the polluted environment.
•
Hold with one hand the halfmask before the face and with the other hand
pull the harness behind the back of the neck, making sure it is not rolled up.
•
Fasten the two buckles at the end of the harness straps at the base of the
back of the neck.
•
Adjust the tension of the straps, if necessary, by slipping them through the
end buckles.
