28
• Pass equipment to Service Department.
6.
Routine Maintenance
To be performed after use of equipment.
6.1.
Cleaning, Disinfecting, Drying
As required carefully clean, disinfect and thoroughly dry contaminated dirty
components after use.
When using baths containing cleaning and disinfecting solutions, dipped components
and assemblies must be agitated manually.
DPI recommends that no form of mechanical, electrical or ultrasonic agitation be used.
Do not dip the hood assembly or the valve in cleaning or disinfecting solutions.
Safety Note: Refer to manufacturers’ usage instructions when using cleaning and
disinfecting agents, it is important that attention be paid to concentration and
reaction times. Do not use organic solvents, such as Acetone, Alcohol, White Spirit,
Trichloroethylene or similar.
Use clean cloth, moistened in cleaning or disinfecting solution to remove dirt and
contaminants from valve/pressure reducer and hood assembly.
Remove disinfecting fluid residue with clean cloth moistened with clean water,
followed by drying.
DPI recommends the following:
Cleaning agent: cod. N. 4437.0370
Do not exceed a temperature of 30°C
Note: Rinse off cleaning solution in clean water before disinfecting.
Disinfecting agent: item no 4437.0360
Do not exceed a temperature of 30°C
Rinsing and Drying
Remove cleaning and disinfecting solutions by rinsing in clean running water, followed
by drying. When drying components, do not exceed a temperature of 60°C.
Summary of Contents for 4342.8225
