DPX8000 Series Deep Service Switching Gateway User
Configuration Guide Firewall Service Board Module v1.0
10
Note:
If you configure the server inner port in the advanced configuration, it will connect to the destination port after it
switched destination NAT.
1.4.4
One to one NAT
To enter the one to one NAT page, you choose
Firewall module > Firewall > NAT > One to one NAT
, as
shown in Figure1-9.
Figure1-9
One to one NAT
Table1-7 describes the details of one to one NAT configuration.
Table1-7
One to one NAT configuration
Item
Destination
Serial number
Displays the serial number of one to one NAT policy.
Public interface
Displays the outbound interface of one to one NAT policy.
One to one NAT
Displays the inner address of one to one NAT policy.
Public address
Displays the public address of one to one NAT policy.
Operation
Click the copy icon, and then you copy a one to one NAT policy.
Click the delete icon, and then you can delete a one to one NAT policy.
To configure one to one NAT configuration:
Click
icon of the one to one NAT policy
Configure the public interface of one to one NAT policy
Configure the inner address of one to one NAT policy
Configure the public address of one to one NAT policy
After you finished the above steps, you can click
Ok
button in the upper right