DPX8000 Series Deep Service Switching Gateway User
Configuration Guide Firewall Service Board Module v1.0
30
Type in a name of IPsec rule which is correspond to the requirement
Click
Enable
IPsec
operation
Configure the local IP address item, such as 10.66.0.11
Configure the local device ID item which provides four types of obtaining method, such as you can enable
the auto.
In the authentication method item, it provides two kinds of authentication method in which you can select
one, such as pre-shared-key.
After you finished the above configuration, click Ok button on the upper right.
3.1.3
DPVPN
To enter the DPVPN page, you choose
Firewall module > Firewall VPN > IPsec > DPVPN
, as shown in
Figure3-2.
Figure3-2
DPVPN
Table3-3 describes the details of DPVPN
Table3-2
DPVPN
Item
Description
Enable DPVPN
Allows you to enable the DPVPN function.
Work mode
Select a work mode for the DPVPN, including spoke and hub.
Hub IP
Enter the hub IP address.
Protected subnets
Add a subnet that need protected
Template connection
Configure a template connection for DPVPN configuration
To view the IPsec connection display interface:
Select a query item, and make a choice form local IP address and remote IP address and connection name
Enter the keyword of display IPsec connection
Click the query button
