DPtech FW1000 Series Firewall Products User Configuration Guide
3-86
Select an interface for the area configuration
Configure the advanced configuration for the area
Click
Ok
button in the upper right corner on the webpage
Table3-19 describes the details of the OSPF interface configuration.
Table3-19
OSPF interface configuration
Item
Description
Interface name
Displays all interface names of the device.
Hello interval
Allow you to configure the Hello packet time interval (Default is 10 second).
Dead interval
Allows you to configure the Dead time interval that the interface doesn’t receive
Hello packet (Default is 40 second).
Authentication information
Allows you to select authentication mode.
Advanced configuration
Allows you to configure the OSPF advanced configurations.
To configure OSPF interface configuration, you should:
Configure time interval for the interface to send Hello packet.
Configure time interval for the interface to send Dead packet.
Configure OSPF authentication information for the interface (including None, Test authentication and Md5
authentication)
In the advanced configuration, you should select Cost value, DR election priority, working mode and interface
type for the interface.
Click
Ok
button in the upper right corner on the webpage.
Note:
After you enable OSPF, the OSPF function and OSPF advance configuration can be used.
3.10.6.2 OSPF interface information
To enter the OSPF interface information, you can choose
Basic> Network > IPv4 unicast routing > OSPF
interface information
from navigation tree, as shown in Figure3-49.