DPtech FW1000 Series Firewall Products User Configuration Guide
3-92
3.11 IPv6 unicast routing
IPv6 unicast routing allows user to configure IPv6 static routing manually. After you configured IPv6 static routing,
data packets will be transmitted to the desired destination.
3.11.1 Static route
To enter the static route page, you can choose
Basic> Network > IPv6 unicast routing > Static route
from
navigation tree
,
as shown in Figure3-55.
Figure3-55
Static route
To configure static route in batch, you should take the following steps:
Click
Browse
button to select a configuration file from local disk.
Click
Ok
button and then static route configuration file is imported immediately.
Click
Export
button to export all static routes.
To manually configure the IPv6 static route, you should:
Set the IPv6 destination subnet IP address, subnet mask.
Select outbound interface and configure the next hop address for the network gateway (next hop)
Select route priority, type and weight in the advanced configuration.
After you click
Ok
button, the manually created static routes take effect immediately.
3.11.1.1 Basic routing table
Basic routing table provides users with the function of querying detailed routing information. User can click all
routes or specify the destination subnet radio box to query the basic routing table.
