DPtech FW1000 Series Firewall Products User Configuration Guide
3-98
To configure the OSPFv3 area configuration:
Click create an area
Type in area ID
Add the interface into the new created area.
Click
Ok
button in the upper right.
Table3-31 and Table3-32 describes the details of OSPFv3 interface configuration.
Table3-31
OSPFv3 interface configuration
Item
Description
Interface name
Displays all interfaces of the device.
Hello time interval
Specify the hello packet time interval for an interface.
Dead time interval
Displays the dead time interval of an unreceived interface.
Instance ID
Specify the Instance ID
Advanced configuration
Specify interface OSPFv3 protocol and all its advanced configuration.
To configure OSPFv3 configuration:
Set hello packet time interval for an interface.
Set the dead time interval of hello packet.
Specify the instance ID
Configure the item in advanced configuration, including cost, DR, working mode and MTU.
Click
Ok
button in the upper right.
Note
:
To configure OSPFv3 configuration, you must add interface into OSPFv3 protocol.
OSPFv3 advanced configuration shows in Figure3-61.
Figure3-61
OSPFv3 advanced configuration