DPtech FW1000 Series Firewall Products User Configuration Guide
7-202
Click the
add button and type the name: research and development department.
IP address range: 192.168.4.0-192.168.4.255, mask: 24 exclude IP: 192.168.4.8. Click the
Ok
button in the
upper right corner.
Choose
Service > Access control > Rate limitation >
to enter the rate limitation interface.
Create a rule of the rate limitation: such as bandwidth1
Type a name for the rate limitation rule: bandwidth1
Select the
Enable
status
Configure rate limitation parameter, select a type of service: file transfer and configure rate limitation as:
1Mbps
Click the
Ok
button in the upper right corner on the webpage.
Click rate limitation per IP address select tab
Create a rule of the rate limitation per IP address: bandwidth2
Configure a name for the rate limitation: bandwidth2
Select the
Enable
status
Configure rate limitation parameter, select a type of service: HTTP download and configure the rate limitation
as: 1Mbps
Click
Ok
button in the upper right corner on the webpage.
Choose
Basic > Network management > Network object > Security zone
to enter the security zone
interface.
Select trust security zone, interface: eth0/0 and eth0/5
Select untrust security zone, interface: eth0/3
Click
Ok
button in the upper right corner on the webpage.
Reference the above mentioned IP address, security zone and rate limitation rule to packet filtering policy.
7.2 Access Control
7.2.1 Introduction to the Access Control
The device according to the application protocol to which receiving packets belong decides the service to which
packet belongs and blocks all packets for this kind of service.
