DPtech LSW5003 Series Industrial Ethernet Switch Installation Manual
Chapter 2Installation
9
Figure1-6
LC type connector appearance
Figure1-7
SC connector appearance
Note:
Using optical fiber to connect network device, make sure that the type of the optical fibre
connector should correspond to the optical module.
Before connecting optical fiber, make sure that local transmitter optical power isn
’
t beyond the
upper limit of the optical module. Otherwise it may damage optical module.
3.Ethernet optical interface fiber
For 1000M Ethernet optical interface, you can select single-mode or multi-mode optical fiber to
connect Ethernet and according to 1000M Small Form-factor Pluggable (1G SFP) to select optical fiber.
These kinds of SPF interfaces are LC fiber connector, requiring the optical fiber with LC optical fiber
connector. All optical modules support hot swapping. XFP optical module and LC optical fiber
connector are as shown in following figure.
