DPtech LSW5602 Ethernet Switch Installation Manual
Chapter1 Product Introduction
1-23
Figure1-18
LC connector diagram
Figure1-19
SC connector diagram
Note:
Before connecting an optical fiber, make sure that the connector and cable type match the hot swappable
interface module.
Before connecting a fiber, make sure that the optical power at the receivingend does not exceed the upper
threshold of the optical receive power of the transceiver module. Otherwise, the transceiver module
maybe damaged.
1.4.3.3 Optical Fiber For Connecting Ethernet Optical Interface
For 1000M Ethernet optical interface, you can use single-mode or multi-mode module fibre to connect
Ethernet and you can choose corresponding optical fibre for the1000M Small Form-Factor Pluggable
(for short 1G SFP), which is LC optical fibre connector, requiring you to use optical fibre with LC optical
connector. All optical modules support hot plug, XFP optical module and with LC type optical fibre
connector, as shown in Figure1-8 and Figure1-9.
