DPtech LSW5602 Ethernet Switch Installation Manual
Chapter 5 Maintenance and Troubleshooting
4-5
Figure4-6
Settings tab
4.1.2
Booting the Switch
4.1.2.1 Verifying Installation before Power-up
Before powering up the switch, check that:
Both the power cord and the grounding wire are correctly connected.
Proper power supply is used.
The console terminal has been started and the related parameters have been set on it.
!
Caution
：
Before powering up the switch, please verify the power switch position of the switch. When danger
happens you can power off the switch.
4.1.2.2 Powering up the Switch
Powering up the switch
4.1.2.3 Verifying Installation before Power-up
Method: start up your device, and then you can hear fans whirling, put your hand near the ventilation hole,
you can feel air intake and exhaust from the ventilation hole.
Verify the indicator on the front panel display normally.
