DPtech WCS 7000 Series Wireless Access Controller User Configuraiton Guide
49
Configure OSPF authentication information for the interface (including None, Test authentication and Md5
authentication)
In the advanced configuration, you should select cost value, dr election priority, working mode and interface
type for the interface.
Click
Ok
button in the upper right corner on the webpage.
Note:
After you enable the OSPF option, OSPF function and OSPF advance configuration can be used.
3.5.5.2 Displaying OSPF interface information
Select
AC> Network management > IPv4 unicast routing > OSPF > OSPF interface information
from
navigation tree to enter the Displaying OSPF interface information page, as shown in Figure3-22.
Figure3-22
Displaying OSPF interface information
Table3-12 describes the details of the displaying OSPF interface information.
Table3-12
Displaying OSPF interface information
Item
Description
Querying item
Allows you to select an item to be queried
Keyword
Interface information that contains keyword.
Interface name
Displays the OSPF interface.
To which area belongs to
Displays the interface to which area belongs.
Interface status
Displays the interface status.
COST
Displays the interface COST value.
DR
Displays the DR of the interface in the area.
BDR
Displays the BDR of interface in the area.
Neighbor number
Displays the neighbor numbers of the interface.
To configure the OSPF interface information, you should:
