24
Replacement parts
The service life of the UVA low pressure tubes and the
face tanner bulb is approx. 500 hours. Ensure that genu-
ine parts are used for replacement during all
maintenance work.
The type designation of the UVA low pressure tubes, the
face tanner tubes*) and the filter panels*) is also specified
on the unit sticker (on the right rear next to the power
cable).
Order these parts specifying the unit model no. (on the
rating plate) from your service department or dealer.
1. UVA low pressure lamp
VIVA Fun Power 100 W 2 m 1,0 %
Part No. 20012626
2. UVA low pressure lamp
Dr. Kern excellent ER 100 W (only for type 24/1)
Part No. 20008772
3. Starter Philips Cleo Power 100 - 180 W
Part No. 20002592
4. High pressure lamp
400 w 230 v - R7s (only for type 24/1)
Part No. 20008812
5. Filter glass for face tanner
Type Uvisol 85 175 x 165 x 3
(only for type 24/1)
Part No. 20009447
6. Safety glass
175 x 165 x 2 (only for type 24/1)
Part No. 20009507
Guarantee
The guarantee is taken over according to the legal regulations
at present.
Manufacturer's warrenty
- The period of warrenty starts from the date of purchase
and lasts up to 12 months.
- Always include the completed warrenty certificate when
returning equipment.
- The warrenty expires for appliances which have been
modified without manufacturer's explicit agreement.
- Damages caused by incorrect operation or handling
through non-authorized persons are not covered under
the terms of warranty.
- In the event of a claim, please indicate the serial number
as well as the article code number and type name with
expressive description of the fault.
- This warrenty covers damaged parts but no defects due to
wear and tear.
In case of complaint please return the equipment in its origi-
nal packaging or other suitable packaging (caution: danger
of transport damage) to our service department. Always
include the completed warrenty certificate when returning
equipment.
Possible shipping costs arising from the transport to and
from point of repair cannot be borne by us.
Always include the completed warrenty certificate when
returning equipment.
Outside of Germany please contact your specialist dealer in
case of warranty claims. Direct warranty processing with our
service department is in this case not possible.
Equipment start-up date:
Stamp and signature of the authorized electrician:
Instructions for disposal of packaging
All packaging and accessory material used by us bears
the recycling trademark (Interseroh mark) and should thus
be returned to an appropriate recycling center.
Place the paper, cardboard and corrugated packaging
materials as well as the synthetic packaging into the
appropriate containers or bins provided.
We allow only recyclable accessory packaging material
02**
PE
PP
PS
05
06
In the examples above, the materials listed stand for the
following:
PE
for polyethylene**
02 D PE-HD;
04 D PS-LD
PP
für polypropylene
PS
für polystyrene
Caution!
Waste Disposal Act of 27.08.1986
Tanning lamps are not to be disposed of in
domestic rubbish bins; rather, they must be
disposed of separately (hazardous waste
disposal).
Disposal of waste originating from private
households and commercial sources is possible
via municipal hazardous waste collection points.
Lamps must be delivered to disposal sites intac
t.
Service address:
DR. KERN GmbH
Adolf-Weiß-Str. 43
35759 Driedorf, Germany
Tel. +49 (0)2775 82-240
Fax +49 (0)2775 82-455
servicecenter@dr-kern.de
www.dr-kern.de
Please keep this address in a safe place, along with
the Installation Guide. So that we may answer your
questions quickly and competently, always give us
the data contained on the ID plate, such as model
number, article number and manufacture number.
