Stand foot
Dr. Mach
Lamps and Engineering
Edition 01
03.02.2000 / Bak Page 3/11
1. Safety instructions
The stand foot may not be connected to the mains until it has been fully assembled and in-
stalled.
The manufacturer is only responsible for operational safety of the stand foot when repairs and
modifications are carried out by his own staff or by persons who guarantee compliance with
the safety regulations.
The manufacturer is not responsible for damage to persons or property caused by incorrect or
improper use, or when used for incorrect purposes.
General information
These installation instructions must be kept on the lamp together with the relevant
operating instructions for consultation at any time.
All Dr. Mach stand lamps are supplied with all
installation and connection parts and compo-
nents.
For packaging reasons, the five-foot stand is
supplied in dismantled state. The stand tube is
always assembled as a unit and only needs to be
attached to the foot with the lower fastening
screw.
The lamp is supplied with integrated connection
lead and earthed plug.
The socket to be used for the lamp must be in-
stalled according to the requirements stipulated
by the IEC or VDE 0107.
Please check that the earthed socket is available
within the working area of the lamp.
