Stand foot
Dr. Mach
Lamps and Engineering
Edition 01
03.02.2000 / Bak Page 6/11
4. Mounting instructions
Extent of supply
•
1x 5-footed plastic central base
•
2x extension arms with blocking rollers
•
2x extension arms with electrically conductive rollers
•
1x extension arm with roller
•
1x cam catch plate
•
1x cheese head screw M8 with lock washer
•
1x stand tube
•
Lamp head with arm
•
Mounting instructions/Instructions for use – stand
•
Instructions for use – lamp head
4.1 Mounting the stand
For mounting the stand proceed as follows:
•
Place the central base
1
onto the stand tube
∅
25
2
. The stiffness is to ensure a tight fit that
is free from any movement.
•
Pre-mount the cam catch plate
3
(cams point
inwards), with the lock washer
4
and cheese
head screw M8
5
, so that the extension arm
6
can still fit easily into the central base. Insert
the extension arm
6
into the central base from
above holding the cam catch plate
3
against
from the opposite side.
•
Insert the other 4 extension arms
7-10
in the
sequence shown in the left figure into the cen-
tral base. The extension arms are held by the
cams of the cam catch plates.
Remark: Mount the two locking rollers 11 and
12, and the two electrically conductive rollers 13
and 14 as shown in the figure (not next to each
other).
•
Tighten the catch plate with an Allen key SW6
(approx. 15Nm).
The cams of the catch plate must mate with the
drill holes of the extension arms so that every
extension arm is tightly fitted to both the central
base and stand tube.
The cams also prevent the extension arms from
being pulled out.
2
14
9
10
12
1
6
8
13 7
11
3
4
5
