CONTACT US AT
www.DRpower.com
13
Chapter 4: Maintaining the DR 2-CYCLE TILLER CULTIVATOR
This chapter covers regular maintenance procedures that will ensure the best performance and long life of your DR 2-CYCLE
TILLER CULTIVATOR.
Regular Maintenance Checklist
Note: Consider that the service intervals shown are the maximum under normal operating conditions. Increase frequencies under
extremely dirty or dusty conditions.
Procedure
Before Each
Use
Every 35
Hours
Check the Engine mixed Fuel Level
▲
Clean the Tines and Tine Shield*
After each use
Check the general condition of the machine, e.g.
nuts, bolts, welds, etc.
▲
Clean Engine Exterior & Cooling Fins
▲
Clean Air Filter
▲
Check Tines for Wear
▲
Replace Air Filter
▲
Replace Spark Plug
▲
* Cover the Engine Muffler, Carburetor, and Air Filter before using a hose to clean the Tines and Tine Shield.
Lubrication
The Tines Drive Transmission Case has grease installed at the factory. We recommend that once a year to have the Transmission
opened by a qualified service professional and the grease level checked. Add a molylithium type grease only if the level of the
grease is below the top of the gears. DO NOT OVERFILL.
Prior to performing any maintenance, you must first shut off the Engine; wait five minutes to allow parts to cool and disconnect
the Spark Plug wire, keeping it away from the Spark Plug.
